Toma Model Works
Prototype
SR&RL No.7, 0-4-4T Forney locomotive, built by the Portland Company.
Instruction
See the URL on the label of the package box. You can easily access by scanning the QR code that also printed on the label with your cell phone camera.
Features
- HO scale 9mm gauge, it can run on small curves over dia 100mm, and designed with "a two-point support system" so that the driving wheels follow steps on rails.
- Equipped with our new 12V coreless motor, M0.2 gear with spur gear deceleration enables realistic run from extremely low speeds (63mm/s-6V*). The drive chassis is coated to reduce wear and already painted black.
- The parts are made of 3D printed high performance UV resin. There are almost no "3D printed steps" on flat surfaces.
-All supports are already removed so there is no need to worry about damage to parts. It can be completed with super glue and tapping & screwing. No soldering required.
- As with the nomal plastic models, it can be painted with surfacers and paints for plastic models.
- Instant lettering sheet is included in the kit.
- Rear coupler included or Microtrains No. 2001(Not included) will fit the end beam. Front coupler is printed with knuckle to the front beam.
*Millimeter speed per second at 6V that was calculated from no-load motor rotation speed.
#1311 HOn30 SR&RL #7, RTR drive chassis
Normaler Preis
¥26,500
Prototype
SR&RL No.7, 0-4-4T Forney locomotive, built by the Portland Company.
Instruction
See the URL on the label of the package box. You can easily access by scanning the QR code that also printed on the label with your cell phone camera.
Features
- HO scale 9mm gauge, it can run on small curves over dia 100mm, and designed with "a two-point support system" so that the driving wheels follow steps on rails.
- Equipped with our new 12V coreless motor, M0.2 gear with spur gear deceleration enables realistic run from extremely low speeds (63mm/s-6V*). The drive chassis is coated to reduce wear and already painted black.
- The parts are made of 3D printed high performance UV resin. There are almost no "3D printed steps" on flat surfaces.
-All supports are already removed so there is no need to worry about damage to parts. It can be completed with super glue and tapping & screwing. No soldering required.
- As with the nomal plastic models, it can be painted with surfacers and paints for plastic models.
- Instant lettering sheet is included in the kit.
- Rear coupler included or Microtrains No. 2001(Not included) will fit the end beam. Front coupler is printed with knuckle to the front beam.
*Millimeter speed per second at 6V that was calculated from no-load motor rotation speed.